Server Technology switched pro2 - Page 161

Switched PRO2 – User Guide
Using the Command Line Interface (CLI) • 161
set ipv4, set ipv6
Sets IPv4 and IPv6 configuration values.
Command Syntax
set ipv4 address <ipv4 address>
set ipv4 gateway <ipv4 address>
set ipv4 subnet <ipv4 address>
set ipv6 address <ipv6 address>
set ipv6 gateway <ipv6 address>
set ipv6 prefix <ipv6 CIDR prefix>
Parameters
The set ipv4 and set ipv6 commands use the following parameters:
Ipv4 address
Uses the format of XXX.XXX.XXX.XXX, where XXX=0-255.
Ipv6 address
Uses the format of XXX.XXX.XXX.XXX.XXX.XXX.XXX.XXX, where
XXXX=0-0xFFFF.
Ipv6 CIDR prefix
Uses the format of /0-64.
Command Access
Admin level only; no access in Demo mode
set ldap
Sets LDAP configuration values.
Command Syntax
set ldap bind [simple | tls | md5]
set ldap binddn <distinguished name>
set ldap bindpw <password>
set ldap groupattr <group attribute>
set ldap groupsearch basedn <distinguished name>
set ldap groupsearch [disabled | enabled]
set ldap groupsearch useattr <user attribute>
set ldap primary <hostname>
set ldap secondary <hostname>
set ldap port <port>
set ldap userbasedn <distinguished name>
set ldap userfilter <filter>
Parameters
The set ldap command uses the following parameters:
bind
Sets the bind method for the LDAP server.
binddn
Sets the distinguished name (DN) for the bind.
bindpw
Sets the password for the bind.
groupattr
Sets the user class distinguished name (DN) or names of groups a user
is a member of.
groupsearch
Sets the bind to search groups for the username in addition to
searching the usernames for its list of group memberships.