Server Technology switched pro2 - Page 162

Switched PRO2 – User Guide
Using the Command Line Interface (CLI) • 162
hostname
Sets the hostname of the Directory Services server.
port
Sets the port number for the LDAP server. 1-65535 (default 389).
userbasedn
Sets the base distinguished name (DN) for the username search at
login.
userfilter
Sets the filter used for the username search at login.
Sub-Parameters
The set ldap command uses the following sub-parameters:
simple
Uses simple bind method.
tls
Uses bind with TLS. (TLS version 1).
md5
Uses Digest MD5 bind.
basedn
Base Distinguished Name (DN).
useattr
Sets the user attribute to search for.
Command Access
Admin level only; no access in Demo mode
set ldapgroup
Sets configuration values for LDAP group access rights.
Command Syntax
set ldapgroup access [admin }| admin | ononly | poweruser | rebootonly | user |
viewonly] <groupname>
set ldapgroup sysmon [disabled | enabled] <groupname>
Parameters
The set ldap group command uses the following parameters:
access
Sets the access type of an LDAP group.
Note: On-Only, Reboot-Only, and View-Only are available for Switched
PRO2 products.
sysmon
Sets system monitor access for an LDAP group.
Sub-Parameters
The set ldap group command uses the following sub-parameter:
groupname
Name of the LDAP group to change access rights. 0-32 characters.
Command Access
Admin level only