Server Technology switched pro2 - Page 172

Switched PRO2 – User Guide
Using the Command Line Interface (CLI) • 172
Sub-Parameters
The set sensor command uses the following sub-parameters:
alarmhi
Sets high alarm value.
alarmlo
Sets low alarm value.
warnhi
Sets high warning value.
warnlo
Sets low warning value.
min <= alarmlo <= warnlo <= warnhi <= alarmhi <= max
Command Access
Admin level only
set snmp
Sets SNMP configuration values.
Command Syntax
set snmp iprestrict [none | trapdests]
set snmp syscontact <system contact>
set snmp syslocation <location>
set snmp sysname <system name>
set snmp trap dest1 <hostname>
set snmp trap dest2 <hostname>
set snmp trap format [v1 | v2c | v3]
set snmp trap repeat <repeat time>
set snmp v2 [disabled | enabled]
set snmp v2 [getcomm | setcomm | trapcomm] <comm string>
set snmp v3 [disabled | enabled]
set snmp v3 [roauth | rwauth] [none | md5 | md5des]
set snmp v3 [roauthpass | rwauthpass] {password} verify password}
set snmp v3 [roprivpass | rwprivpass] {password} {verify password}
set snmp v3 [rousername | rwusername | trapusername] <username>
Parameters
The set snmp command uses the following parameters:
iprestrict
Sets to only allow to trap destinations to have SNMP access
syscontact
System contact string. 0-63 characters.
syslocation
System location string. 0-63 characters.
sysname
System name string. 0-63 characters.
trap
Sets trap notification options.
v2
Sets to allow access with SNMPv2.
v3
Sets to allow access with SNMPv3.