Server Technology switched pro2 - Page 173

Switched PRO2 – User Guide
Using the Command Line Interface (CLI) • 173
Sub-Parameters
The set snmp command uses the following sub-parameters:
dest1
First SNMP trap destination. 0-63 characters.
dest2
Second SNMP trap destination. 0-63 characters.
format
Format of SNMP trap and header.
repeat
Sets the SNMP trap repeat time for object in an event condition. 1-
65535 seconds.
getcomm
Read community string for SNMPv2. 0-32 characters. Default is public.
setcomm
Read/write community string in SNMPv3. 0-32 characters. Default is
blank.
trapcomm
Community string in SNMPv2 traps for authentication. 0-32 characters.
ro-prefix
Read-Only SNMPv3 user.
rw-prefix
Read/write SNMPv3 user.
auth
Authentication type for an SNMPv3 user.
authpass
Authentication password for an SNMPv3 user. 0-39 characters.
privpass
Privacy password for an SNMPv3 user. 0-31 characters.
username
Username for an SNMPv3 user. 0-31 characters.
trapusername
Username for trap authentication for SNMPv3 traps. 0-31 characters.
none
No authentication or privacy is used (authpass and privpass are not
used).
md5
Authentication but not privacy is used (privpass is not used).
md5des
Authentication and privacy are used
Command Access
Admin level only; No access in Demo mode.