Server Technology switched pro2 - Page 177

Switched PRO2 – User Guide
Using the Command Line Interface (CLI) • 177
set telnet
Sets Telnet configuration values.
Command Syntax
set telnet [disabled | enabled]
set telnet port <port>
Parameters
The set telnet command uses the following parameters:
port
Sets the port for Telnet connections 1-65535 (default is 23).
Command Access
Admin level only; no access in Demo mode
set trend
Sets power trending configurations.
Command Syntax
set trend [disabled | enabled]
Command Access
Admin level only; no access in Demo mode
set unit
Sets PRO2 configuration values.
Command Syntax
set unit assettag <name | id> <asset tag>
set unit display [auto | inverted | normal] <name | id | ALL>
set unit email [disabled | enabled] <name |id | ALL>
set unit identify [disabled | enabled] <name | id | ALL>
set unit name <name | id> <new name>
For Switched PRO2 products only:
set unit osequence [normal | reversed] <name | id | ALL>
Factory unlocked only:
set unit golden [disabled | enabled]
set unit prodsn <name | id> <prod sn>
Confirmation required:
set unit purge <name | id | ALL>
set unit snmpt [disabled | enabled] <name | id | ALL>
Parameters
The set unit command uses the following parameters:
assettag
The asset tag value of the unit. 0-32 characters.
display
Sets the orientation of the displays on a unit.
email
Email notifications for an event.
golden
Set to have the system not retain unit information.