Server Technology switched pro2 - Page 178

Switched PRO2 – User Guide
Using the Command Line Interface (CLI) • 178
identify
Set to enable/disable flashing display.
name
The name of the unit. 0-32 characters.
osequence
Sets the outlet sequence order for a unit.
prodsn
Sets the product serial number for a unit. 0-32 characters.
purge
Removes all stored information for a unit.
snmpt
SNMP trap notifications for unit events.
Sub-Parameters
The set unit command uses the following sub-parameters:
auto
Set automatic display orientation using internal orientation sensor.
Inverted
Set display to be upside down.
normal
Set display to be right-side up; set outlet sequencing to be 1 to n.
reversed
Set outlet sequencing to be n to 1.
Command Access
Admin level only
set ups
Sets UPS device configuration values.
Command Syntax
set ups addline <UPS#> <line name | id | ALL>
set ups commstr <UPS#> <get community string>
set ups delline <UPS#> <line name | id | ALL>
set ups host <UPS#> <hostname>
set ups oidspoll <UPS#> <oid>
set ups onbattery <UPS#> <value>
set ups onutility <UPS#> <value>
set ups port <UPS#> <port>
set ups type <UPS#> <value>
Parameters
The set ups command uses the following parameters:
UPS#
The number of the UPS to change. 1-8.
addline
Adds the specified line to be protected by the UPS.
commstr
Sets the community string for polling the UPS by SNMP. 0-32
characters.
delline
Removes the specified line from a UPS.
host
Hostname for polling the UPS by SNMP. 0-63 characters.