Switched PRO2 – User Guide
Using the Web Interface • 85
What Data Does Trending Measure?
REQUIREMENTS
For the Trending feature to occur and display (for viewing only) on the PRO2 GUI at System > Trending, SNTP
must be enabled to keep track of when daily measurements are taken.
Certain measurements for PIPS and POPS (if POPS is present) are tracked by the Trending feature:
For all PIPS cords/phases/lines, the following measurements are tracked:
• Phase voltage
• Line current
• Cord watts
• Cord power factor
WHAT IS MEASURED?
For all POPS outlets, the following measurements are tracked:
• Current
• Watts
• Power factor
ADDITIONAL TRACKED METRICS
For all of the above PIPS/POPS measurements, the following metrics will also be tracked:
• Minimum measurement
• Maximum measurement
• “In-use average” measurement
Note: PIPS is a standard feature on all PRO2 units, but if the unit does not have POPS, then only the PIPS
measurements will be tracked.
REQUIREMENTS
For the Trending feature to occur and display (for viewing only) on the PRO2 GUI at System > Trending, SNTP
must be enabled to keep track of when daily measurements are taken.
Certain measurements for PIPS and POPS (if POPS is present) are tracked by the Trending feature:
For all PIPS cords/phases/lines, the following measurements are tracked:
• Phase voltage
• Line current
• Cord watts
• Cord power factor
To Next Page
Loading...