How to use the appliance
25
Pause a running program and open the door, if
needed
Press START/PAUSE button to pause a running
program.
If the water level and/or temperature in the drum
are/is not high, the DOOR LOCK indicator light
turns off. You can open the door, for example to add
more laundry, or to remove laundry which was
loaded by mistake. Press START/PAUSE button
again to proceed with the program.
9. Cancelling a running program, if needed
Turn the Linear mark on the wash cycle selector
knob under the symbol “ “ to turn off the
appliance.
If the water level and/or temperature are/is low
enough, the door is unlocked and can be opened.
The door remains locked if there is higher water
level in the drum. To unlock the door, firstly turn
the wash cycle selector knob to select the Spin
program , then press the SPEED button to set the
Spin program off (all spinning speed value
indicator light go out on the display).
Press START/PAUSE button to run Spin
program. The water is pumped out from the drum
during the cycle. The door unlocks at the end of
the program.
10. Switch off the appliance after program End
At the end of the cycle, the message “End” is
shown on the digital display.
The door can only be opened when the DOOR
LOCK indicator light goes out.
Check that the DOOR LOCK indicator light is off,
then open the door and take out the laundry.
Turn the Linear mark on the wash cycle selector
knob under the symbol “ “ to turn off the
appliance.
Turn off the tap.
Leave the door ajar to let the interior of the appliance
to dry.
To Next Page
Loading...
