SERVIS S328514MLW - Page 33

Troubleshooting
31
Problem
Possible cause / solutions
The machine continuously
fills with water and
continually drains away
 The top of the drain hose is too low – It must be fitted at a height between
65 and 100 cm from the floor (see “Installation”).
 The end of the drain hose has been pushed too far down the standpipe,
the
hose elbow should be fitted 4’ (100mm) from the end of the drain hose.

The end of the drain hose is submerged in the discharged water.
The discharged water flows
back into the appliance
 If the end of the drain hose touches the discharged water (water drained
from washer), it (the discharged water) can be sucked back into the
appliance and may damage the appliance or textiles.
The local part of the
control panel is heated
 This is the slight heating effect of the electronic components on the
computer board on the back of the control panel.
After drying, there are
water drops on the door
and drum
 During drying, the door may be stained with water drops, please wipe off
the water drops.
 Do you put in too much or too thick clothes.
The drying effect is poor
and uneven.
 Are clothes that are not easy to dry (such as thick cotton fabrics) and fabric
that are easy to dry (such as synthetic fabrics) are dried together?
 Do you put too much clothes for drying?
 When only running the “Drying” program, do you separate the dehydrated
and entangled clothes be putting them in drum?
 Due to different types and quantities of clothes, uneven drying may occur,
For uneven drying, please add regular drying.
 Is the faucet turned off during drying?
 Is the filter of the drain pump blocked during drying?
 Is the drain hose bent, twisted or blocked during drying?
General
 Your appliance contains sensors that monitor progress during the wash
cycle (eg: Water level, Temperature, Out of balance loads, Wash
time/progress). Normally, if your appliance successfully completes the
cycle, there is unlikely to be anything wrong!