19
STEP 3.
MODE
TARE
POWER
EnAbLE
UnI7S
Press the MODE key to enter the units menu and the display will read “EnAbLE”.
STEP 4.
MODE
TARE
POWER
9 YES
EnAbLE
Press the MODE key. The first selection displayed is “g yES” which represents
grams enabled. To enable grams press the MODE key. To disable grams,
press the TARE key to display “g nO” , then press the MODE key. These yes/no
selections are also displayed for ounces (O), carats (C) and user definable
units (U).
Note: To enable or disable any unit of measure, the procedure outlined
above must be completed for each unit. If you make a change and
escape before finishing the complete procedure (which ends with U
units) the change will not take effect.
SETTING THE USER DEFINED UNIT OF MEASURE
A user defined unit can be programmed for any unit of measure, such as ml
for measuring volume or $ for measuring value. To measure in “x” units, first
calculate the ratio you wish to enter. If your ratio is in “x” units per gram, you
would enter a factor (positive conversion number). If your ratio is in grams
per “x” unit enter a divisor (negative conversion number). To define the “x”
unit perform the following procedure.
STEP 1.
TARE
POWER
MODE
FUnC
0.00
Hold down the TARE key then press the MODE key. Release both keys, the
display will read "FUnC".
To Next Page
Loading...
Need help?
General
