22
SELECTING FLOW RATE (PER SECOND)
The factory default of the “x” user defined unit is for flow rate displayed in
grams per second. Flow rate can be enabled or disabled at will using the
following procedure. When the flow rate is disabled, the “x” unit will display
weight in the unit of measure it was last set to display. The factory default
for “x” with flow rate disabled is grams.
STEP 1.
TARE
POWER
MODE
FUnC
0.00
Hold down the TARE key then press the MODE key. Release both keys, the
display will read "FUnC".
STEP 2.
MODE
TARE
POWER
UnI7SFUnC
Press the TARE key three times to display “UnITs”.
Note: To escape anytime during this procedure, press the TARE key until
"ESCAPE" is displayed and press the MODE key.
STEP 3.
MODE
TARE
POWER
EnAbLE
UnI7S
Press the MODE key to select “UnITS” and enter the units menu. The display
will read “EnAbLE”.
STEP 4.
MODE
TARE
POWER
PEr SECEnAbLE
Press the TARE key twice to display “PEr SEC”, then press the MODE key. The
display will then read “rATE y” for rate yes.
To Next Page
Loading...
Need help?
General
