Setra Super Count
TM
Operator's Manual 17
ENTERING, RECALLING & CLEARING ADDITIONAL ID ENTRIES
A total of seven separate ID numbers may be entered. These multiple ID numbers may be used to
represent additional information related to a particular batch (i.e. vendor, lot number, etc.)
To enter additional ID numbers, use the following procedure:
1. Press the setup/cal key.
2. Enter the number you wish to assign (up to 25 digits, as indicated above).
3. Press the id key.
4. Enter a number from 1-7 to indicate which ID entry this data is to be assigned to.
5. Repeat steps 1-4 to assign additional ID entries to a given batch.
NOTE: a. The ID entry numbers one, five and seven is not erased by the reset key or when the
scale is powered off. These entry numbers can be used to store the Company name
and address or any information that you wish to print with every transaction.
b. ID field number six cannot be used if your Setra scale is equipped with the optional time/
date feature.
To recall any of the seven ID entries, perform the following procedure:
1. Press the setup/cal key.
2. Press the display key.
3. Press the id key.
4. Enter a number from 1-7 to indicate which ID entry is to be recalled.
To clear any one of the seven ID entries, perform the following procedure:
1. Press the setup/cal key.
2. Press the — key.
3. Press the id key.
4. Press the ID number from 1-7 to indicate which ID entry is to be cleared.
NOTE: To clear all ID entries at once, except ID numbers one, five and seven, press the reset key.
(ID numbers one, five and seven must be cleared using the procedure outlined directly above.)
When the seven additional ID numbers are printed, the identifying entry numbers will not be printed.
We therefore suggest these numbers be formatted, if possible, to be easily recognized by the users
as to what their meaning signifies. (e.g. A date can be entered as 01-05-91, or an employee id
number may be 123-45-6789).
To Next Page
Loading...
Need help?
General
