28
Setra Super Count
TM
Operator's Manual
PRINTING LABELS WITH SEQUENTIAL NUMBERING
The Super Count scale can number packages sequentially (ex. 1 of 3). The sequence can only be
printed using a script program.
To set the numbering sequence:
1. Press the setup/cal key, then press the count key. The display will read “01oF01”.
The first two digit number, XX, will increment by one each time the print key is pressed, until XX
equals the YY value. The second two digit number, YY, represents the total number of pack-
ages in a lot.
2. Press the setup/cal key to change the sequence numbers. The scale will display “_ _ oF01”. To
retain the XX value previously displayed simply press the setup/cal key. To set a new XX value,
enter a number (0-99). Press the setup/cal key.
3. The scale will display “XXoF_ _”. To retain the YY value previously displayed, press the setup/
cal key. To set a new YY value, enter a number (0-99) which is equal to the total number of
packages in the sequence. Press the setup/cal key.
To view the current sequence on the scale display:
1. Press the setup/cal key, then press the count key. The display will read “XXoFYY”.
The first two digit number, XX, will increment by one each time the print key is pressed, until XX
equals the YY value. The second two digit number, YY, represents the total number of pack-
ages in a lot.
2. Press the clear key to accept these numbers and resume normal operation.
To Next Page
Loading...
Need help?
General
