sewerin EX-TEC SR4 - EX-TEC Charging Procedures

19
3.03.0
3.03.0
3.0
Charging techniqueCharging technique
Charging techniqueCharging technique
Charging technique
☞
The The
The The
The EX-TEC® SR5, SR4, SR2
and and
and and
and VARIOTEC® 8
detectors detectors
detectors detectors
detectors
must not be recharged in an explosive gasmust not be recharged in an explosive gas
must not be recharged in an explosive gasmust not be recharged in an explosive gas
must not be recharged in an explosive gas
atmosphere !atmosphere !
atmosphere !atmosphere !
atmosphere !
When fully charged the detectors have a
maximummaximum
maximummaximum
maximum of 8 hours'
operating time with the pump running.
For charging you need the
HS charging adapterHS charging adapter
HS charging adapterHS charging adapter
HS charging adapter (see illustration),
which can be used either in the workshop or in the standby vehicle.
The following items can be
connected to the side of the
charging adapter:
• 230 V mains power pack ≈,
• 12 V= vehicle adapter,
• 24 V= vehicle adapter.
ChargingCharging
ChargingCharging
Charging
Switch the detector off and plug it into the charger. A display of the
following type appears:
• the detector has 5 operating hours
left (= 5 bars) and will take 3 hours
to become fully charged
• if it is fully charged all the bars are
visible and the number display
disappears
• the detector can be left in the
charger until it is next needed