unit is used.
·In page mode, the horizontal or vertical motion unit differs depending on
the starting position of the printable area as follows :
1. When the starting position is set to the upper left or lower right of
the printable area using ESC T, the horizontal motion unit (x) is
used.
2. When the starting position is set to the upper right or lower left of
the printable area using ESC T, the vertical motion unit (y) is used.
[Reference] ESC ＼, GS $, GS ＼, GS P
ESC % n
[Name] Select/cancel user-defined character set
[Format] ASCII ESC %
n
Hex 1B 25
n
Decimal 27 37
n
[Range] 0≤
n
≤ 255
[Description] Selects or cancels the user-defined character set
·When the LSB of n is 0, the user-defined character set is canceled.
·When the LSB of n is 1, the user-defined character set is selected.
[Details] ·When the user-defined character set is canceled, the internal character
set is automatically selected.
·
n
is available only for the least significant bit.
[Default] n = 0
[Reference] ESC &, ESC ?
ESC & y c1 c2 [x1 d1…d(y x x1)]..[ xk d1..d(y x xk)]
[Name] Define user-defined characters
[Format] ASCII ESC & y c1 c2
[x1 d1...d(y × x1)]...[xk d1...d(y × xk)]
Hex 1B 26 y c1 c2
[x1 d1...d(y × x1)]...[xk d1...d(y × xk)]
Decimal 27 38 y c1 c2
[x1 d1...d(y × x1)]...[xk d1...d(y × xk)]
[Range]
y
= 3
32
≤
c1
≤
c2
≤ 126
0
≤ x ≤ 12 Font A (when font A (12 x 24) is selected)
0
≤ x ≤ 9 Font B (when font B (9 x 17) is selected)
0
≤ d1 ... d(
y
x
x
k) ≤ 255
[Description] Defines user-defined characters
·y specifies the number of bytes in the vertical direction.
TITLE : WTP-150
Page -30 -
To Next Page
Loading...
