Need help?Do you have a question about the SEWOO WTP-150 and is the answer not in the manual?
Details printing method, dot density, direction, width, speed, and line spacing.
Details character sets, structure, size, and characters per line for various emulations.
Describes partial cut functionality and paper feeding requirements after cutting.
Details paper type, form, width, roll size, and spool diameter.
Details RS-232, Centronics parallel, and USB interfaces.
Specifies parameters and settings for RS-232 serial communication.
Lists serial interface parameters like baud rate, data bits, parity, and stop bits.
Explains how the printer transitions between on-line and off-line states.
Details PIN, SIGNAL, I/O, and DESCRIPTION for the RS-232 connector.
Illustrates a typical RS-232 serial connection setup with wiring.
Details the Centronics parallel interface, signals, and timing specifications.
Specifies timing characteristics for data reception in compatibility mode.
Details the USB 2.0 interface, connector, and typical connection example.
Diagrams showing the pin layouts for D-SUB serial and parallel ports.
Refers to Section 2.1 for detailed interface connector information.
Details input voltage and current consumption for the power connector.
Describes the drawer kick-out connector, pin assignments, and signals.
Explains the format and notation used for control commands.
Details commands for printing characters and advancing paper.
General| Print Method | Direct Thermal |
|---|---|
| Resolution | 203 DPI |
| Weight | Approx. 1.6 kg |
| Paper Width | 80mm / 58mm (with paper guide) |
| Type | Thermal Printer |
| Connectivity | USB, Serial, Parallel |
| Dimensions | 145 x 195 x 148 mm |
| Paper Thickness | 0.06 ~ 0.08mm |
| Interface | USB + Serial or USB + Ethernet or USB + Parallel |
| Power Supply | 24V DC |
To Next Page
