SEWOO WTP-150 - Page 37

[Reference] ESC 3
ESC 3 n
[Name] Set line spacing
[Format] ASCII ESC 3
n
Hex 1B 33
n
Decimal 27 51
n
[Range] 0≤
n ≤ 255
[Description] Sets the line spacing to [
n x (vertical or horizontal motion unit)] inches.
[Details] ·The line spacing can be set independently in standard mode and in
page mode.
·The horizontal and vertical motion unit is specified by GS P.
Changing the horizontal or vertical motion unit does not affect the
current line spacing.
·The GS P command can change the horizontal (and vertical) motion unit.
However, the value cannot be less than the minimum vertical movement
amount, and it must be in even units of the minimum vertical movement
amount.
·In standard mode, the vertical motions until (y) is used.
·In page mode, this command function as follows, depending on the
starting position of the printable area :
①When the starting position is set to the upper left or lower right to
the printable area using ESC T, the vertical motion unit
(y) is used.
②When the starting position is set to the upper right or lower left of
the printable area using ESC T, the horizontal motion unit
(x) is used.
·The maximum paper feed amount is 1016 mm {40” }. Even if a paper
feed amount of more than 1016 mm{40” }is set, the printer feeds the
paper only 1016 mm{40” }
[Default] Line space is equivalent to approximately 4.23 mm{1/6” }.
[Reference] ESC 2, GS P
ESC = n
[Name] Set peripheral device
[Format] ASCII ESC =
n
Hex 1B 3D
n
Decimal 27 61
n
TITLE : WTP-150
Page -36 -