·This command has no effect in page mode.
·After printing by FF is completed or by using ESC S, the printer returns to
standard mode.
·This command sets the position where data is buffered to the position
specified by ESC T within the printing area defined by ESC W.
·This command is switches the setting for the following commands (in
which the values can be set independently in standard mode and page
mode) to those for page mode.
① Set right-side character spacing : ESC SP, FS S
② Select default line spacing : ESC 2, ESC3
·Only valve settings is possible for the following commands in page
mode; these commands are not executed.
① Turn 90
° clockwise rotation mode on/off: ESC V
② Select justification: ESC a
③ Turn upside-down printing mode on/off: ESC {
④ Set left margin: GS L
⑤ Set printable area width: GS W
·The following command is ignored in page mode:
①Execute test print: GS W
·The following command is not available in page mode:
①
Print NV bit image : FS p
②
Define NV bit image : FS q
③
Print raster bit image : GS v 0
·The printer returns to standard mode when power is turned on, the printer
is reset, or ESC @ is used.
[Reference] FF, CAN, ESC FF, ESC S, ESC T, ESC W, GS $, GS ＼
ESC M n
[Name] Select character font
[Format] ASCII ESC M n
Hex 1B 4D n
Decimal 27 77 n
[Range] n= 0, 1 , 48, 49
[Description] Selects character fonts
TITLE : WTP-150
Page -41 -
To Next Page
