SEWOO WTP-150 - Page 70

orientation:
①When the print starting position is set to the upper left or lower right of
the printing area using ESC T (data is buffered in the direction
perpendicular to the paper feed direction):
Command using x : ESC SP, ESC $, ESC W, ESC ＼, FS S
Command using y : ESC 3, ESC J, ESC W, GS $, GS ＼, GS V
②When the print starting position is set to the upper right or lower left of
the printing area using ESC T (data is buffered in the paper feed
direction):
Command using x: ESC 3, ESC J, ESC W, GS $, GS ＼
Command using y: ESC SP, ESC $, ESC W, ESC ＼, FS S, GS V
·The command does not affect the previously specified values.
·The calculated result from combining this command with others is
truncated to the minimum value of the mechanical pitch.
[Default]
x = 180, y = 360
[Reference] ESC SP, ESC $, ESC 3, ESC J, ESC W, ESC ＼, GS $, GS L, GS V, GS W,
GS ＼
① GS V m ② GS V m n
[Name] Select cut mode and cut paper
[Format] ①ASCII GS V
m
Hex 1D 56
m
Decimal 29 86 m
②ASCII GS V m n
Hex 1D 56
m n
Decimal 29 86 m n
[Range] ① m = 1,49
②
m =66 , 0 ≤ n ≤ 255
[Description] Selects a mode for cutting paper and executes paper cutting. The value of
m selects the mode as follows:
m Print mode
1, 49 Partial cut(one point center uncut)
66
Feeds paper(cutting position + [n x(vertical motion unit)]) , and cuts the
paper partially(one point center uncut)
TITLE : WTP-150
Page -69 -