Shanling M0 Pro - SYSTEM SUBMENU; Update Library; Bluetooth

SHANLING M0 PRO – ADVANCED USER MANUAL
Page 6
Folder Skip
Setting affecting file playback in Folders Submenu.
If enabled, and if Play Mode is set up to “Shuffle” or “List Play”, after last file from chosen
folder is played, M0 PRO will automatically follow up with file from following folder.
SYSTEM SUBMENU
Update Library
To use My Music submenu, M0 PRO needs to scan Micro SD card for all the files.
• Automatic - if enabled, M0 PRO will automatically scan Micro SD card each time card is
inserted into M0 PRO and each time M0 PRO is disconnected from computer.
• Update Music - click to perform one-time scan of all files.
While updating, please don’t operate M0 PRO and wait until it finishes updating the music
library.
Note: For audio files to be recognized and organized into My Music submenu, files need to be
correctly tagged.
Bluetooth
• Bluetooth - Click to turn on Bluetooth functions.
• Quality – Choose Bluetooth codec matching codec used by your headphones or
speakers. Please refer to specification of given headphones or speakers for this
information. This setting has no effect on M0 PRO as Bluetooth receiver.
• Bluetooth Headset Volume Control – If connected Bluetooth headphones or
speakers are too quiet, use this setting to adjust total volume level. Available for most
Bluetooth headphones and speakers with dedicated volume control.
• Search - Click to scan for available Bluetooth devices. Found devices will be listed
under “Compatible device”. Click any of listed device to start pairing.
All previously paired devices are listed under “Paired”. M0 PRO will connect to them
automatically if they are turned on and within range of Bluetooth.
To unpair device, click trash can icon next to paired device.
Note 1: To pair headphones or speakers with M0 PRO, they must be firstly put into pairing
mode. Please refer to their manual for more information.
Note 2: LDAC codec offers three different settings:
• LDAC-HQ – Highest bit rate and best sound quality, excellent quality of Bluetooth signal
is needed.
• LDAC-NORMAL – Lower bit rate and lower sound quality, quality of Bluetooth signal can
be lower.