Sewing on buttons
Move the drop feed control to right side to lower
the feed dogs. (1)
Change presser foot to button sewing foot.
Position the work under the foot. Place the
button in the desired position, lower the foot. Set
the pattern selector knob on zig zag stitch " } ".
Adjust the stitch width between "3" - "5"
according to the distance between the two holes
of the button. Turn the handwheet to check that
the needle goes cleanly into the left and right
holes of the button. Set the pattern selector
knob on straight stitch "i ", and sew a few
securing stitches. Set the pattern selector knob
on zig zag stitch " } ", and slowly sew on the button with about
10 stitches. Set the pattern selector knob on straight stitch " i ",
and sew a few securing stitches.
If a shank is required, place a darning needle on top of the
button and sew. (3) For buttons with 4 holes, sew through the
front two holes first (2), push work forward and then sew
through the back two holes. (3)
O
4}
@
54
To Next Page
Loading...
Need help?
General
