96-723, 97-715, 97-716, 97-717 • REV. 2/04
9
PRESSURE WASHER
OPERATOR’S MANUAL
SHUTTING DOWN AND CLEAN-UP
STEP 1: Remove de-
tergent suction tube
from container and in-
sert into one gallon of
fresh water. Slide
nozzle forward for low
pressure or to connect
black detergent
nozzle. Pull trigger on
spray gun and siphon
water for one minute.
STEP 2: Turn off machine by
flipping switch on rear of mo-
tor.
STEP 5: Disconnect the garden
hose from the water inlet on the
machine.
STEP 6: Disconnect the high
pressure hose from high pres-
sure outlet.
STEP 7: Engage
the spray gun
safety lock.
STEP 4: Press trigger
to release water pres-
sure.
Pump
Water
Inlet
High
Pressure
Outlet
Safety
Latch
STORAGE
Pump Storage
CAUTION: Always store your pres-
sure washer in a location where the
temperature will not fall below 32° F
(0° C). The pump in this machine is
susceptible to permanent damage if
frozen.
FREEZE DAMAGE IS NOT COVERED
BY WARRANTY.
If you must store your pressure washer in a location
where the temperature is below 32° F, you can mini-
mize the chance of damage to your machine by drain-
ing your machine as follows:
1. Stop the pressure washer and detach supply hose
and high pressure hose. Squeeze the trigger of the
spray gun to drain all water from the wand and
hose.
2. Restart pressure washer and let it run briefly (about
5 seconds) until water no longer discharges from
the high pressure outlet.
STEP 3: Turn off water supply.
To Next Page
Loading...
Need help?
General
