sharkclean.comsharkclean.com
CLEANING THE FILTER
MAINTENANCE
Remove and empty the dust bin. Clean any hair or
debris o the Anti-Tangle Comb on the back of the
dust bin.
Pull filter out of the dust bin by the tabs.
Lightly tap the filter to remove dust and debris. Reinsert the filter into the dust bin. Slide the dust
bin back into the robot.
CLEAN FILTER EVERY WEEK.
REPLACE FILTER EVERY TWO MONTHS. See sharkaccessories.com for replacement filters.
CLEANING THE MULTI-SURFACE BRUSHROLL
MAINTENANCE
Push up on the tabs on the brushroll access door,
then lift o the door.
Lift out the brushroll.
Remove the blue cap on the end of the brushroll.
Do not let the metal cylinder inside the cap fall out.
Clean o any hair or debris, then replace cap. Clean
the brushroll periodically and whenever hair appears.
Reinstall the brushroll, inserting the flat end first.
Close the brushroll access door and press down
until it clicks into place.
NOTE: If the metal cylinder falls out of the brushroll cap, reinsert it in the hole on the inside of the cap. When cutting away
debris, be sure not to cut the brushroll or any other parts of the robot.
THE BRUSHROLL NEEDS OCCASIONAL MAINTENANCE.
REPLACE BRUSHROLL EVERY 6 to 12 MONTHS, OR WHEN VISIBLY WORN. See sharkaccessories.com for
replacement parts.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
