sharkclean.comsharkclean.com
MAINTENANCE
CLEANING AND REPLACING THE FILTER
Remove and empty the dust bin. Clean any hair or
debris o the Anti-Tangle Comb on the back of
the dust bin.
Pull filter out of the dust bin by the tabs.
Lightly tap the filter to remove dust and debris. Reinsert the filter into the dust bin, then slide the
dust bin back into the robot.
Regularly clean and replace the filter to keep your vacuum's suction power optimal.
IMPORTANT: DO NOT use water when cleaning the filter.
SELF-CLEANING BRUSHROLL
MAINTENANCE
To access the brushroll, push up on the tabs on the
brushroll access door, then lift o the door.
The Self-Cleaning Brushroll actively removes hair wrap while your robot cleans. If some hair remains
wrapped around the brushroll, continue cleaning to allow the brushroll to clean itself.
NOTE: Clean the robot filter once a month, and replace it every six months. See sharkaccessories.com for replacement filters.
Lift out the brushroll. Remove the cap on the end
of the brushroll. Clean o any hair or debris, then
reattach cap.
Reinstall the brushroll, inserting the flat end first.
Close the brushroll access door and press down until
both sides click into place.
NOTE: If the metal cylinder falls out of the brushroll cap, reinsert it in the hole on the inside of the cap. When cutting
away debris, be sure not to cut the brushroll.
NOTE: Replace brushroll every 6 to 12 months, or when visibly worn. See sharkaccessories.com for replacement parts.
To Next Page
Loading...
Need help?
General
