sharkclean.comsharkclean.com
PREPARING FOR USE
NOTE: If the low charge light is blinking red, there is not enough charge for the robot to return to the dock. Manually
place the robot on the dock.
TIP: To preserve battery life, turn o the power switch if robot will not be used for a long period of time. Unit should be
recharged at least once every 3 months.
CHARGE INDICATOR LIGHTS
PREPARING FOR USE
BUTTONS AND INDICATOR LIGHTS
The blue indicator lights show how much charge is remaining.
While the robot is charging, both blue LED lights will cycle. When charging is complete, both blue lights will
illuminate steadily. It may take up to 5 hours to fully charge your robot.
In Use
Full
Charge
(Blue)
Partial
Charge
(Blue)
Low
Charge
(Red)
While
Charging
(Blue)
No Charge
or O
!
DOCK BUTTON
Press to stop cleaning and
send robot back to the
charging dock.
CHARGE INDICATOR LIGHTS
Display the amount of charge
remaining in the battery.
“!” ERROR INDICATOR
See Troubleshooting section
for full list of error codes.
WI-FI INDICATOR
Blue light: connected to
Wi-Fi.
Red light: not connected.
Flashing blue: setup mode.
No light: not set up yet.
CLEAN BUTTON
Press to begin a cleaning
session. Press again to stop.
NAVIGATION MODULE
Upward-facing sensor that
identifies unique reference
points to aid advanced
navigation.
Please keep clear and do not
cover.
To Next Page
Loading...
Need help?
General
