Shark IQ Self-Empty - Robot Component Cleaning and Care; Cleaning Sensors and Charging Pads

sharkclean.eusharkclean.eu
SHARK ANTI HAIR WRAP TECHNOLOGY®
MAINTENANCE
To access the brush-roll, push up on the tabs on the
brush-roll access door, then lift o the door.
Lift out the brush-roll, and clean o any debris.
Reinstall the brush-roll, inserting the flat end first.
Close the brush-roll access door and press down
until both sides click into place.
NOTE: When cutting away debris, be sure not to cut the brush-roll.
NOTE: Replace brush-roll every 6 to 12 months, or when visibly worn. See sharkclean.eu for replacement parts.
The Anti Hair wrap Brush-roll removes debris over time as it cleans. If some debris
remains wrapped around the brush-roll, continue cleaning to allow the brush-roll to
remove it.
If some debris remains on the brush-roll after continued cleaning, follow the steps below
to remove it.
CLEANING SENSORS AND CHARGING PADS
CLEANING SIDE BRUSHES
MAINTENANCE
Carefully unwind and remove any string or hair
wrapped around brushes.
Gently wipe brushes with a dry cloth. To reinstall,
snap the brushes over the pegs. Spin the brushes
manually to make sure they are installed correctly.
CLEAN SENSORS AND CHARGING PADS AS NEEDED. With a dry cloth, gently dust o the sensors and
pads located on the bottom of the robot and on the base.
NOTE: Remove and replace any side brushes that are bent or damaged. To remove a brush, lift it o its peg.
NOTE: Cloth not included.
IMPORTANT: The robot uses cli sensors to avoid stairs and other steep drops. Sensors may work less eectively when
they are dirty. For best results, clean sensors regularly.
CLEAN SIDE BRUSHES AS NEEDED.
ENGLISH