sharkclean.comsharkclean.com
MAINTENANCE
EMPTYING THE ROBOT DUST BIN
Press the Dust Bin Release Button and slide out the
dust bin.
CAUTION: Turn o power before performing any maintenance. To turn the
robot power o, press the DOCK button on the robot for 5-7 seconds.
To open the dust bin, press the finger slots and lift
the lid.
Every time you empty the dust bin, lightly tap dust
and dirt o the filter, then use a dry cloth or soft
brush to remove any remaining debris.
NOTE: After emptying the dust bin, make sure to
reinsert it completely, until it clicks into place.
MAINTENANCE
Regularly clean the filters to keep your vacuum's suction power optimal. Replace filters every 6-12
months or as needed.
CLEANING AND REPLACING THE BASE FILTERS
IMPORTANT: DO NOT use soap when cleaning the filters.
CLEAN POST-MOTOR FILTER EVERY YEAR
Press the button at the top of the Filter Door and
slide the latch down to lift Filter Door o. Remove
the Post-Motor Filter from the base by pulling the
tab down. Tap the filters clean over the trash. Do not
use water or soap to clean filters as this will cause
damage. To reinstall the post-motor filter, insert it
into the base and replace the filter door.
CLEAN PRE-MOTOR FILTERS ONCE A MONTH
To open the filter housing lid, hold the top left edge
of the base and pull up on the lid. With the lid open,
remove the foam filter by the top handle, then lift out
the felt filter underneath. Tap the filters clean over the
trash, then rinse with cold water ONLY, as soap may
damage them. Allow filters to air-dry completely before
reinstalling them. The filters must be installed correctly
for the base to work properly. Reinsert the felt filter
first, then the foam filter.
Filter
Door
The dust cup lid can be snapped on and o for
additional cleaning. Do not use water to clean the
top lid, as this may damage the robot filter.
To Next Page
Loading...
Need help?
General
