sharkclean.comsharkclean.com
CHARGING THE BATTERY
Remove the handheld vacuum from the wand by
pressing the Wand Release Button and pulling
up. Plug the charger into the charging port on the
handheld vacuum.
To put the vacuum in storage mode, press the
MultiFLEX Wand Unlock Latch while folding the
handheld vacuum forward until the wand clicks and
locks. Plug the charger into the charging port on the
handheld vacuum.
To remove the battery, squeeze the Battery
Release Button and slide backwards. Plug the
charger into the charging port on the battery.
USING THE LI-ION CHARGER
IN THE VACUUM: STANDARD WAND
IN THE VACUUM: MULTIFLEX® WAND OUT OF THE VACUUM
NOTE: MultiFLEX wand is not included with all configurations. See enclosed Quick Start Guide for your unit’s configuration.
SETTINGS
NOTE: For deep cleaning per ASTM F 608 (embedded dirt in carpets) please use setting II, Carpet. The Carpet setting
should also be used when cleaning stuck-on dust and debris.
Slide switch to the bottom to turn o power.
To begin vacuuming in Standard Mode, slide switch
to the desired setting.
Bare Floor/Small Area Rugs
The brushroll spins slowly to clean bare floors and
small arearugs.
Carpet
The brushroll spins faster to pick up debris below
the surface ofyour carpets.
For an added boost in power, pull the Trigger
on the handheld vacuum. Release it to return to
normal power.
OFF SETTING I
SETTING II BOOST MODE
Plug the Li-Ion Charger into a wall outlet.
LI-ION CHARGER
To Next Page
Loading...
Need help?
General
