4.5. Calibrate the Compass
The compass needs to be calibrated in the following situations:
When you use the SharkX for the first time
When you fly at a new place (more than 100m away)
When the SharkX has not been used for more than one month
DO NOT calibrate the compass in the presence of a strong magnetic interference, such
as magnetite, parking structures, and steel reinforcements underground.
DO NOT carry ferromagnetic materials with you during calibration, such as mobile
phones (aside from the phone you may have already connected to your controller)
DO NOT mute your mobile device during calibration in case you cannot hear voice
prompts.
To calibrate the SharkX compass
choose an outdoor open area to carry out the calibration procedures.
Two ALTERNATIVE ways of entering compass calibration:
4.5.1. Entering calibration on RC
Step 1: Press and hold two middle buttons (see image below) till the RC beep and the
screen will show “CAL command successfully”.
To Next Page
Loading...