Sharp 27DV-S100

110
27DV-S100
27DV-CS10
NOTES:
1. The unit of resistance "ohm" is omitted
(K=1000 ohms, M =1 Meg ohm).
2. All resistors are 1/10 watt, unless otherwise noted.
3. All capacitors are 50V, unless otherwise noted.
4. All capacitors are µF, unless otherwise noted. (P: µµF)
5. (G) indicates ±2% tolerance may be used.
VOLTAGE MEASUREMENT CONDITIONS:
1. All DC voltages are measured with DVM connected
between points indicated and chassis ground, line
voltage set at 120V AC and all controls set for normal
picture unless otherwise indicated.
2. All voltages measured with 1000µV B&W or Color
signal.
DESCRIPTION OF SECTION SCHEMATIC DIAGRAM
WAVEFORM MEASUREMENT CONDI-
TIONS:
1. Photographs taken on a standard gated color bar
signal, the tint setting adjusted for proper color. The
wave shapes at the red, green and blue cathodes of
the picture tube depend on the tint, color level and
picture control.
2.
indicates waveform check points (See chart,
waveforms are measured from point indicated to
chassis ground.)
å AND SHADED ( ) COMPONENTS
= SAFETY RELATED PARTS.
' MARK= X-RAY RELATED PARTS.
DRGANNES MARQUES å ET HACHRES ( ):
PIECES RELATIVES A LA SECURITE.
MARQUE
' : PIECS RELATIVE AUX RAYONS X.
This circuit diagram is a standard one, printed circuits
may be subject to change for product improvement
without prior notice.
1 2 3 4 5 6
7 8 9 0 q w
e r t
o p a
y u i
1.9Vp-p
Horiz. Rate
1.9Vp-p
Horiz. Rate
300mVp-p
Horiz. Rate
0.98Vp-p
Horiz. Rate
280mVp-p
Horiz. Rate
0.96Vp-p
Horiz. Rate
0.6Vp-p
Horiz. Rate
0.8Vp-p
Horiz. Rate
4.0Vp-p
Horiz. Rate
3.4Vp-p
Horiz. Rate
3.6Vp-p
Horiz. Rate
127Vp-p
Horiz. Rate
135Vp-p
Horiz. Rate
140Vp-p
Horiz. Rate
50.9Vp-p
Vert. Rate
1.8Vp-p
Vert. Rate
727mVp-p
Horiz. Rate
180Vp-p
Horiz. Rate
2.5Vp-p
Horiz. Rate
1210Vp-p
Horiz. Rate
327Vp-p
Vert. Rate
WAVEFORMS