17
3
BYPASS FEED (including special paper)
The multi-bypass tray (AL-1551CS) or the single bypass (AL-1215/AL-1530CS/AL-
1540CS) can be used to feed standard paper, transparency film, labels, envelopes,
and other special purpose paper. Paper measuring from 3-1/2" x 5-1/2" to 8-1/2" x
14" and in the weight range of 14 lbs. to 34.5 lbs. (52g/m
2
to 128g/m
2
) can be used in
this tray. (For paper weighing from 28 lbs. to 34.5 lbs. (105g/m
2
to 128g/m
2
),
8-1/2" x 11" is the maximum size.)
The multi-bypass tray (AL-1551CS)
1
Open the multi-bypass tray and extend the tray.
2
Set the paper guides to the paper width. Insert the paper (print
face down) all the way into the multi-bypass tray.
• The multi-bypass tray (AL-1551CS) can hold maximum of 50 sheets
of paper. (Capacity will vary depending on the type of paper loaded.)
The single bypass (AL-1215/AL-1530CS/AL-1540CS) can hold one
sheet of paper.
• The original image must be smaller than the paper or media for
copying. If the original image is bigger than the paper or media, this
may cause smudges on the edges of the copies.
To close the multi-
bypass tray,
perform step 1
and then step 2 in
the illustration and
push the round
projections at the
right of the tray
until they click.
Print face
AL-1215_1530-1551CS.book 17 ページ ２００２年８月７日 水曜日 午前９時３４分
To Next Page
Loading...
Need help?
General
