Scanning From the Operation Panel
125
7. Scanning
5. In the Actions field, select Prompt for which program to run.
6. Click the Apply button.
7. Repeat Steps 4 through 6 for each of events SC2 through SC6 (select Prompt
for which program to run for each event). When finished, click the OK button
to close the window.
8. When you begin scanning after selecting one of the scan menus on the
operation panel, the following window will appear on your computer. Select
Sharp Button Manager I for the program to launch. In addition, to stop the
window from appearing each time you use that scan menu, select Always
use this program for this action.
To Next Page
Loading...
