28
Watching TV
Auto power-off at a designated time
This function is conveniently used when, for instance,
going to bed while watching TV.
1
2
NOTE
• When the time has been set, countdown automatically
starts.
• Five minutes before the preset of time expires, the
remaining time displays each minute.
• Select “Off” by pressing SLEEP to cancel the sleep timer.
Press SLEEP.
• Remaining time displays when sleep timer has
been set.
Each time you press SLEEP, the remaining
time switches as shown below.
Press MENU and the MENU screen displays.
1
Press
c
/
d
to select “Power Control”.
Press
a
/
b
to select “No Signal Off”, and then
press ENTER.
3
Press
c
/
d
to select “Enable”.
• Five minutes before the power shuts down, the
remaining time displays every minute.
4
Press MENU and the MENU screen displays.
1
Press
c
/
d
to select “Power Control”.
Press
a
/
b
to select “No Operation Off”, and
then press ENTER.
3
Press
a
/
b
to select “30min.” or “3hr.”.
• Five minutes before the power shuts down, the
remaining time displays every minute.
4
NOTE
• “Disable” is the factory preset value.
Auto power-off when there are no
operations performed
You can set the TV to automatically power off when no
TV operation is performed for more than 3 hours.
NOTE
• “Disable” is the factory preset value.
• When a TV programme fi nishes, and the TV receives signal
input, this function may not operate.
Auto power-off after the end of broadcast
You can set the TV to automatically power off in about
15 minutes after the TV goes into a state of receiving
no programme signals, such as the end of a broadcast
day.
Energy conservation settings
2
2
Sleep timer: Remain 2hr. 00min.
0hr. 30min. 1hr. 00min. 1hr. 30min.
2hr. 30min. 2hr. 00min.
Off
LC-42A65M_EN.indb 28LC-42A65M_EN.indb 28 7/18/08 7:13:06 PM7/18/08 7:13:06 PM
To Next Page
Loading...
