21
MAKING COPIES
TWO-SIDED COPYING
Two-sided copying
5
Place the second original face down on the original
table and press the START key again to copy onto the
other side.
●
To stop a copy run during duplex copying, press the CLEAR key.
●
If an uneven number of originals are set, press the ORIGINAL TO
COPY key at the end of the copy run to output the last copy.
●
To cancel the duplex copy mode, press the ORIGINAL
TO COPY key repeatedly until the indicators in the
ORIGINAL TO COPY section all go out.
●
The image of every front side can be rotated 180°
using the image rotation feature. This feature is
useful when the originals and copies are in the
landscape (horizontal) orientation and the two-sided
copies are to be read by turning them left to right
rather than top to bottom.
To set this feature, see page 62.
p13-p27_206.p65 7/12/00, 12:0521
To Next Page
Loading...
