3-13
CHAPTER3
COVERS
SPECIAL FUNCTIONS Covers
The COVERS mode is used to place covers on the front, back, or both
the front and back of multipage documents.
●
Front cover sheets can be copied on, but only on the front side even
in the 1-sided to 2-sided and 2-sided to 2-sided copy modes.
The back side of the original designated as the cover will not be
copied.
●
Back cover sheets cannot be copied on, either on the front side or on
the back side.
●
Cover sheets must be fed from the bypass tray and must be the same
size as the copy paper being used to copy the document.
●
When the COVERS mode is selected, the stream feeding mode of
the RADF will always be off.
1
Place the originals in the document feeder tray.
2
Press the 2-SIDED COPY key and select the desired
duplex mode if needed. Press the “OK” key to close the
duplex selection window.
3
Press the SPECIAL MODES key.
●
The SPECIAL MODES screen will appear.
4
Press the “COVERS” key on the touch panel.
●
The setting screen for COVERS will appear.
LOAD COVER STOCK INTO BYPASS-TRAY.
COVERS
FRONT
BACK
FRONT+BACK
YES
NO
PRINT ON FRONT COVER?
CANCEL
OK
OK
To Next Page
Loading...
