2. MAINTENANCE DISPLAY SYSTEM
According to the change in toner and developer life, the LED ON timing is changed.
Toner Life 18K
Remaining quantity check
1 a. Press and hold the density adjustment LIGHT key for more than 5 sec, and the machine
will enter the user program mode.
b. Press and hold the "%"key for more than 5 sec, and the remaining quantity will be
displayed on the copy quantity display in one of the following levels: (Remaining quantity
display levels: 100%, 75%, 50%, 25%, 10%, LO)
c. Press the density adjustment LIGHT key to cancel.
Remaining quantity NEAR EMPTY
About 10%
EMPTY
LED ON Flash
Machine Operation allowed Stop
Developer Life 50K
LED ON at 50K of the developer count.
Machine Selection is available between Not Stop and Stop by Service Simulation (SIM 26-37) Setup.
(If Stop is selected, the LED will flash and stop at 50K)
Default: Not Stop
Clear: SIM 42-1
Maintenance LED Selection is available among 50K, 25K, 10K, 7.5K, 5K, and free (no lighting) with SIM 21-1.
Default: 25K
Clear: SIM 20-1
Machine Not stop.
1 : Installation of a new toner cartridge allows to display the remaining quantity.
To Next Page
Loading...
Need help?
General
