Sharp AR-M237 - Page 221

103
KEY OPERATOR PROGRAMS
8
F-CODE MEMORY BOX
This program is used to program memory boxes for
F-code communication. Three types of memory boxes
can be programmed: F-code memory polling boxes,
F-code confidential boxes, and F-code relay broadcast
boxes. Follow the procedure below to program, edit, or
delete a memory box.
A box name, sub-address, password, and specific
functions are programmed in a memory box.
1
Touch the desired type of memory box
([POLLING MEMORY], [CONFIDENTIAL],
or [RELAY BROADCAST]) in the upper row
of keys.
(The following uses [POLLING MEMORY] as an example.)
The F-code memory box programming screen appears.
2
Touch the [BOX NAME] key.
• The lowest box number that has not yet been
programmed will automatically appear in "No.".
• The character entry screen appears. Enter a name for
the box (maximum of 36 characters).
• To enter characters, see "ENTERING
CHARACTERS" on page 80.
3
Touch the [OK] key.
4
Touch the [SUB ADDRESS] key.
The sub-address/passcode entry screen appears.
5
Use the numeric keys to enter a
sub-address (maximum of 20 digits).
• The characters and # cannot be used in a
sub-address.
• If you make a mistake, press the [CLEAR] key ( )
and then enter the correct number.
• If you do not wish to enter a passcode after entering
the sub-address, go directly to step 8.
6
To enter a passcode, touch the [PASS
CODE] key.
A slash (/) appears after the sub-address.
If you make a mistake, press the [CLEAR] key ( ) and
then enter the correct number.
7
Use the numeric keys to enter a passcode
(maximum of 20 digits).
• Numbers and " " and "#" can be used in a
passcode.
• If you make a mistake, press the [CLEAR] key ( )
and then enter the correct number.
8
Touch the [OK] key.
You will return to the memory box programming screen.
The entered sub-address and passcode will appear.
"REGISTRATION IS COMPLETED." will appear next to
the box "No.".
9
Touch the [NEXT] key or the [EXIT] key.
• To program another memory box, touch the [NEXT]
key.
• To exit, touch the [EXIT] key.
Next, program specific functions of the memory
box as indicated below:
• F-code confidential box (print passcode: page 104)
• F-code relay broadcast box
(end receiving machines: page 104)
Programming an F-code memory box
• When programming a memory box, the
same sub-address as a previously
programmed memory box cannot be used.
However, the same passcode can be used.
• A passcode can be omitted.
• Up to 10 F-code memory boxes can be
programmed. If you attempt to program a
memory box when 10 boxes have already
been programmed, a warning message will
appear and programming will not be
possible. Delete any unneeded F-code
memory boxes (p.105) and then program
the new box.
Note
POLLING MEMORY CONFIDENTIAL
RELAY
BROADCAST
POLLING MEMORY CONFIDENTIAL
KEY OPERATOR PROGRAMS
F-CODE MEMORY BOX
OK
STORE
AMEND/DELETE
RELAY
BROADCAST