Sharp AR-M237 - Programming a Key Operator Code; Using the Key Operator Programs

2
5
TROUBLESHOOTING AND MAINTENANCE
DISPLAY MESSAGES..................................... 58
TROUBLESHOOTING ..................................... 60
MISFEED REMOVAL....................................... 64
● MISFEED REMOVAL GUIDANCE .................64
● MISFEED IN THE RSPF.................................65
● MISFEED IN THE BYPASS TRAY .................66
● MISFEED IN THE MACHINE..........................66
● MISFEED IN THE CENTER TRAY.................68
● MISFEED IN THE UPPER PAPER TRAY ......68
● MISFEED IN THE LOWER PAPER TRAY .....69
● MISFEED IN THE UPPER EXIT AREA
(when a job separator tray kit or finisher
(AR-FN5N) is installed) ...................................70
● MISFEED IN AN OUTPUT TRAY
(when a finisher (AR-FN5N) is installed).........70
REPLACING THE TONER CARTRIDGE ........ 72
STAPLE CARTRIDGE REPLACEMENT......... 73
● STAPLE JAM REMOVAL ...............................74
CHECKING THE TONER QUANTITY AND
TOTAL OUTPUT COUNT ................................ 74
CLEANING THE MACHINE............................. 75
● DOCUMENT GLASS AND RSPF ...................75
● THE BYPASS TRAY PAPER
FEED ROLLER ...............................................75
6
PERIPHERAL DEVICES AND SUPPLIES
PERIPHERAL DEVICES.................................. 76
● FINISHER (AR-FN5N) ....................................77
● 500-SHEET PAPER FEED UNIT/
2 x 500-SHEET PAPER FEED UNIT..............78
STORAGE OF SUPPLIES ............................... 79
● PROPER STORAGE ......................................79
7
APPENDIX
SPECIFICATIONS ........................................... 80
MATERIAL SAFETY DATA SHEET................ 82
INDEX............................................................... 90
● INDEX BY PURPOSE.....................................93