AR-M236/M276/M237/M277 UNPACKING AND INSTALLATION 5 - 8
2) Cut and remove the cut-out portion from the left rear cabinet.
Cut and remove the cut-out portion from the left rear cabinet using
a tool such as nippers. (Be careful about the direction of the tool so
that the cut surface is flat.)
3) Attach the print server card.
Align the connector positions, connect the print server card, and
then secure the card to the option mounting plate in the main unit
using supplied two silver screws (M3 x 8).
4) Reattach the shielding plate.
Reattach the shielding plate using five screws.
5) Connect the cable to the control PWB.
Connect a LAN cable to the connector of the print server card.
Insert the power plug of the copier to the outlet and turn on the
main switch. Then, carry out the following procedure.
6) Check for the print server card.
Use the keys on the operation panel to print a configuration page.
Check that the network interface card has been installed.
7) Check for printing.
Perform setup of the environmental variables.
(For installation of printer drivers on a computer and network set-
tings (IP address input), see the supplied operation manual.)
Execute printing to check to see if printing can be executed prop-
erly.
E. AR-NS2
(1) Packed items
This network scanner kit includes the following items in the package.
• CD-ROM (Network Scanner Tool and Sharpdesk, Installer, Sharp
TWAIN driver, etc.)
• Installation caution sheet and Operation Manual (License numbers
of 10 user clients of Sharpdesk are specified.)
(2) Installation procedure
To use the scanner expansion kit, a S.O.DIMM memory module (128
MB or more) is needed.
If no memory is added, an S.O.DIMM module must be mounted on
PCL PWB.
For the mounting method and the memory capacity, see below.
To enable the scanner function, the product key must be acquired. (For
the method of acquiring the product key, contact the SHARP autho-
rized dealer.)
1) Check the capacity of the Printer PWB memory.
Use the keys of the copier to print the configuration page. (For
details, see the operation manual.)
Check that the capacity of the optional memory is 128 MB or more.
2) Enable the network scanner feature.
To enable the system configuration, use the keys on the copier to
set the mode.
Enter the product key with the key operator program. (Refer to the
Operation Manual of Key Operator Program.)
Setting of the product key is completed. Press the [EXIT] key to
update the system and exit the setting mode.
Cut-out portion
Print server card
Silver screws
(M3 x 8)
Screws
Screws
LAN cable
To Next Page
Loading...
