GB-16
Be sure to disconnect the power cord from the wall outlet or turn off the circuit
breaker before performing any maintenance.
1
TURN OFF THE UNIT
2
REMOVE THE FILTERS
1
Lift the open panel.
2
Push the air fi lters up slightly to unlock them.
3
Pull the air fi lters down to remove them.
3
TAKE OFF THE DEODORANT FILTERS
FROM THE AIR FILTERS
4
CLEAN THE FILTERS
Use a vacuum cleaner to remove dust. If the
fi lters are dirty, wash them with warm water
and a mild detergent. Dry fi lters in the shade
before reinstalling.
5
REINSTALL THE DEODORANT FIL-
TERS
6
REINSTALL THE FILTERS
1
Reins tall the fi lters in the original positions.
2
Close the front panel.
3
Push the arrow-marked of the panel fi rmly
to lock it in place.
AUXILIARY MODE
Use this mode when the remote control is not available.
TO TURN ON
Lift the front panel of the indoor unit and press the AUX.
button on the operation panel.
• The red OPERATION lamp ( ) on the unit will light and the
unit will start operating in the AUTO mode.
• The fan speed and temperature setting are set to AUTO.
TO TURN OFF
Press the AUX. button on the operation panel again.
• The red OPERATION lamp ( ) on the unit will turn off.
NOTE:
If the AUX. button is pressed during normal operation, the unit will turn off.
MAINTENANCE
CLEANING THE FILTERS
The air fi lters should be cleaned every two weeks.
3
1
2
To Next Page
Loading...
Need help?
General
