Sharp BU Series - Loading Batteries; Using the Remote Control

EN-12
REMOTE CONTROL
LOADING BATTERIES
Use two size-AAA (R03) batteries.
1
Remove the battery cover.
2
Insert batteries, making sure the (+) and
( - ) polarities are correctly a lign ed.
• The display indicates “6:00 AM” when
batteries are properly installed.
3
Reinstall the cover.
Battery cover
NOTE:
• The battery life is approximately 1 year in
normal use.
• Replace the batteries when the remote control
displays “
”.
• Rechargeable batteries are not recommended
to use.
• When replacing the batteries, always change
both and use the same type.
• If you will not be using the unit for a long time,
remove the batteries from the remote control.
SETTING THE CURRENT TIME
There are two clock modes: 12-hour mode and
24-hour mode.
1
To set the 12-hour mode, press once.
To set the 24-hour mode, press twice.
2
Press or to set the current
time.
• Hold down the button to advance or
reverse the time quickly.
3
Press .
• The numbers stop blinking and the clock
starts running.
NOTE:
• The current time cannot be set when the timer
is set.
3
2
1
USING THE REMOTE CONTROL
Point the remote control towards the receiver
window and press the desired button. The
unit generates a beep when it receives the
signal.
• Make sure there is no object between the
remote control and the unit.
• The signal e󰀨ective distance is 23ft (7 m).
CAUTION:
• Do not expose the receiver window to direct
sunlight. This may adversely a󰀨ect its operation.
• Use of certain uorescent lighting in the same
room as the indoor unit may interfere with the
transmission signal from the remote control.
• Do not leave the remote control in direct
sunlight or near a heater. Protect the remote
control from moisture and shock.
• The current time cannot be set when the timer
is operating.
Receiver window
1
During operation, press .
• Thermostat display of remote control will
change between “°F” (Fahrenheit) and “°C”
(Centigrade).
1
CHANGING °F/°C DISPLAY