Sharp BU Series - Basic Operation; To Turn off

EN-14
TURN OFF
1
3
2
BASIC OPERATION
1
Press or .
• on the unit lights up.
TO TURN OFF
Press .
• on the unit goes o󰀨.
2
Press or .
The temperature increases by 1°F(0.5 °C) in
sequence.
(COOL/HEAT mode)
The temperature setting range: 61-86°F(16-30°C).
3
Press to set the desired fan speed.
AUTO QUIET SOFT LOW HIGH
NOTE for MULTI ZONE SYSTEM:
• With multi zone system, up to three indoor units connect to one outdoor unit.
• The following di󰀨erent operating modes do not run at the same time.
-HEAT and COOL
-HEAT and DRY
*
COOL and DRY can run at the same time.
(DRY mode is avaliable on App only.)
• The rst running unit has the mode priority.
• The second and/or third unit do not run in conicting modes with the rst unit. When you choose
such modes, the unit will be on hold with a few beeps. The OPERATION Indicator and TIMER
Indicator start blinking.
• If KEEP 50˚F(10˚C) or PLASMACLUSTER mode is operated in the second and/or the third
room while the rst room is in HEAT mode, the fan in the second and/or the third room will stop
intermittently to prevent the room temperature from rising.