Sharp BU Series - Adjusting the Airflow Direction; Plasmacluster

EN-15
ENGLISH
1
VERTICAL AIR FLOW DIRECTION
1
Press .
(COOL mode)
( )
( )
( )
(HEAT mode)
( )
( )
( )
1
HORIZONTAL AIR FLOW DIRECTION
(Only for ZHU Series)
1
Press
.
CAUTION:
Never attempt to adjust the louvers manually.
• Manual adjustment of the louvers can cause
the unit to malfunction.
• When the vertical airow louver is positioned
at the lowest position in the COOL mode for an
extended period of time, condensation may result.
ADJUSTING THE AIRFLOW
DIRECTION
PLASMACLUSTER
PLASMACLUSTER function is ON by
default when the unit is in operation.
.
TO CANCEL THIS FUNCTION
1
Press .
• on the remote control goes o󰀨.
•
turns from blue to green.
• The PLASMACLUSTER indicator goes o󰀨.
(Only for ZHU Series)
NOTE:
• The unit remembers your preference on
PLASMACLUSTER operation upon your next
use.
• Plasmacluster
®
is Sharp’s original technology.
• To perform the PLASMACLUSTER only mode,
press the PLASMACLUSTER button while the
unit is not operating. In this mode, only the
fan operates. The mode symbol of the remote
control will go o󰀨 and the fan speed can not be
set AUTO.
1
For ZU & BU series, you can manually adjust
the airow with the louver lever.
The unit releases Plasmacluster
ions into the room.
Louver lever