Sharp BU Series - Manual On;Off on Unit; Smart Network Function; Tips on Saving Energy

EN-13
ENGLISH
ON/OFF
button
TIPS ON SAVING ENERGY
Use this mode when the remote con-
trol is not available.
TO TURN ON
Press the ON/OFF button.
• The OPERATION indicator ( ) will light up
and the unit will start operating in the AUTO
mode.
• The fan speed and temperature setting are
set to AUTO.
TO TURN OFF
Press the ON/OFF button again.
• The OPERATION indicator ( ) will turn o󰀨.
Pairing the mobile device with the
air conditioner by wireless LAN,
you can operate the air conditioner
and monitor the condition of the air
conditioner by the mobile device.
Please refer to the "wireless LAN
guidebook" to get more information
about the wireless LAN pairing.
MANUAL ON/OFF ON UNIT
SMART NETWORK FUNCTION
Below are some simple ways to
save energy when you use your air
conditioner.
SET THE PROPER TEMPERATURE
• Setting to higher-(lower-)than-necessary
temperature point will result in increased
power consumption.
BLOCK DIRECT SUNLIGHT AND PREVENT
DRAFTS
• Blocking direct sunlight during cooling
operation will reduce power consumption.
• Close the windows and doors during cooling
and heating operations.
SET PROPER AIR FLOW DIRECTION TO
OBTAIN THE BEST AIR CIRCULATION
KEEP FILTER CLEAN TO ENSURE THE MOST
EFFICIENT OPERATION
MAKE MOST OF THE TIMER OFF FUNCTION
TURN OFF THE CIRCUIT BREAKER WHEN
THE UNIT IS NOT USED FOR AN EXTENDED
PERIOD OF TIME
• The unit still consumes a small amount of
power when it is not operating.
The green
WLAN
indicator
will light up when the
wireless
LAN
pairing succeed.
NOTE:
• In the AUTO mode, the unit will automatically
select COOL or HEAT mode by comparing
the room temperature and your desired
temperature.