13
CD-SW340H
2008/April/18 CD-SW340H_AUS
Basic Operation
General control
To turn the power on
Press the ON/STAND-BY button to turn the power on.
Display brightness control
To dim the display brightness, hold down the CLEAR/DIMMER
button on the remote control for 2 seconds or more.
Subwoofer and front speaker light up control
The subwoofer and front speaker will light up according to the level of
the music source played back. To turn on/off the light, hold down the
CLEAR/DIMMER button on the remote control for 2 seconds or more.
Volume auto fade-in
If you turn off and on the main unit with the volume set to 27 or
higher, the volume starts at 16 and fades in to the last set level.
Volume control
Surround mode
Equaliser
When the power is first turned on, the unit will enter FLAT mode.
When the EQUALIZER MODE button is pressed, the current mode
setting will be displayed. To change to a different mode, press the
EQUALIZER MODE button repeatedly until the desired sound mode
appears.
Note:
If the EQUALIZER MODE button is pressed in the surround mode, it
will be cancelled automatically.
After use:
Press the ON/STAND-BY button to enter the power stand-by mode.
TIMER
CD
4
5
3
2
1
Main unit operation:
When the VOLUME control is turned
clockwise, the volume will increase.
When it is turned anti-clockwise, the
volume will decrease.
Remote control operation:
Press the VOLUME (+ or –) button to
increase or decrease the volume.
When the X-BASS (SURROUND)/
DEMO button is pressed, the unit will
enter the surround mode and adjust low
bass and high frequency automatically
according to volume input. To cancel this
mode, press the X-BASS (SURROUND)/
DEMO button again.
No equaliser
For rock music
For classical music
For pop music
Vocals are enhanced
For jazz
30 MAXIMUM0
.....
X-BASS
To Next Page
Loading...
Need help?
General
