Sharp CD-SW340H - Cassette Tape Recording Operations; Programmed Cassette Recording; Recording from Radio; Tape-to-Tape Dubbing

30
CD-SW340H
2008/April/18 CD-SW340H_AUS
Tape Recording
Recording on a cassette tape (continued)
To perform programmed recording:
To stop recording:
Press the (TAPE ) button.
The disc and tape will stop.
 Recording from the radio
To interrupt recording:
Press the button.
To resume recording, press the / (TAPE ) button.
To stop recording:
Press the (TAPE ) button.
Note:
If you hear a whistling noise whilst recording an AM station, move the
AM loop aerial.
 Dubbing from tape to tape
You can record from TAPE 1 to TAPE 2.
To stop dubbing:
Press the (TAPE ) button.
TAPE 1 and TAPE 2 will stop simultaneously.
 Erasing recorded tapes
Note:
Make sure that the TAPE 1 is not in use.
1 Programme discs and tracks (see page 20).
2 Press the button.
3 Press the / (TAPE ) button to start recording.
1 Tune in to the desired station (see page 25).
2 Load a cassette into the TAPE 2 cassette compartment
with the side to be recorded on facing you.
Wind past the leader of the tape, on which recording cannot be
performed.
3 Press the button.
Recording will be paused.
4 Press the / (TAPE ) button to start recording.
1 Press the ON/STAND-BY button to turn the power on.
2 Load a prerecorded cassette
into the TAPE 1 cassette
compartment. Insert a blank
tape into the TAPE 2 cassette
compartment.
It is recommended that the recording tape is the same length as
the master tape.
3 Press the TAPE (1 2) button until “TAPE 1” appears on
the display.
4 Press the button.
Recording will be paused.
5 Press the / (TAPE ) button to start dubbing.
1 Load the tape to be erased into the TAPE 2 cassette
compartment with the side to be erased facing towards you.
2 Press the TAPE (1 2) button until “TAPE 2” appears on the
display.
3 Press the button.
4 Press the / (TAPE ) button to start erasing.