26
CD-SW340H
2008/April/18 CD-SW340H_AUS
Radio
Listening to the radio (continued)
Memorising a station
You can store 40 AM and FM stations in memory and recall them at
the push of a button. (Preset tuning)
Note:
The backup function protects the memorised stations for a few
hours should there be a power failure or the AC power lead become
disconnected.
To recall a memorised station
To scan the preset stations
The stations saved in memory can be scanned automatically.
(Preset memory scan)
To erase entire preset memory
1 Perform steps 1 - 3 in “Tuning” on page 25.
2 Press the MEMORY button on remote control to enter the
preset tuning saving mode.
3 Within 30 seconds, press the PRESET ( or ) button to
select the preset channel number.
Store the stations in memory, in order, starting with preset
channel 1.
4 Within 30 seconds, press the MEMORY button on remote
control to store that station in memory.
If the “MEMORY” and preset number indicators disappear
before the station is memorised, repeat the operation from step
2.
5 Repeat steps 1 - 4 to set other stations, or to change a
preset station.
When a new station is stored in memory, the station previously
memorised for that preset channel number will be erased.
Press the PRESET
( or ) button for less than 0.5 seconds to
select the desired station.
1
Press the PRESET
( or )
button for more than 0.5 seconds.
The preset number will flash and the programmed stations will be
tuned in sequentially, for 5 seconds each.
2 Press the PRESET
( or ) button again when the desired
station is located.
1 Press the ON/STAND-BY button to enter the stand-by mode.
2 Whilst pressing down the button and the button, press
the TUNER (BAND) button until “TUNER CL” appears.
TIMER
CD
4
3
1
5
4
5
3
2
1
PUSH EJECT PUSH EJECT
2
PRESET
TUNER
(BAND)
To Next Page
Loading...
Need help?
General
