1-8-1
E9434HIR
HOW TO INITIALIZE THE DVD RECORDER & VCR
< DVD Recorder Section >
1. Turn the DVD recorder on.
2. Confirm that no disc is loaded or that the disc tray is
open. To put the DVD recorder into the Version
display mode, press [DVD], [CM SKIP], [1], [2], and
[3] buttons on the remote control in the order.
Fig. A appears on the screen.
Model Name :
*******
Firmware Version
BE :
FE :
API :
TT :
DEFAULT SETTING : ENTER
EXIT : RETURN
R2F3000S1E
R20_040_000
2005/8/31
T20163FSU@2
*1: "
*******
" differs depending on the models.
*2: Firmware Version differs depending on the
models, and this indication is one example.
Fig. A Version Display Mode Screen
F/W VERSION
3. Press [ENTER] button, then the DVD recorder starts
initializing. When the initializing is completed, the
DVD recorder exits the Version display mode and
turns off the power automatically.
* To move into the Normal mode from the Version
display mode, press [RETURN] button on the
remote control instead of [ENTER] button.
* When [POWER] button is pressed before [ENTER]
button is pressed, the DVD recorder exits the
Version display mode, then the power turns off.
To put the program back at the factory-default, initialize the DVD recorder & VCR as the following procedure.
To Next Page
Loading...
