1-12-3
E9656FIS
Message Solution
No.
Error
Error Description Priority
to be recorded on this disc.
This program is not allowed
compatible DVD-RW disc.
Insert a ver.1.1 CPRM
28
correspondence to VR Format CPRM
)
once
)
input.
(
Disc which there is not for the
During the CGMS picture
(
possible a record
12
not recordable.
This disc is protected and
in the Disc Setting menu.
Release the disc protect setting
29 Disc Protected Disc. 7
(
No area for new recording
)
Disc is full.
enough recording space.
Insert the recordable disc with
30 There is no it in a space field. 5
(
The maximum is 99.
)
(
The maximum is 999.
)
than 99 titles on one disc.
You cannot record more
Delete unnecessary titles.
31 It is recorded a 99 title.
(
Video Format Disc
)
7
32 It is recorded a 99 title.
(
VR Format Disc
)
8
999 chapters on one disc.
You cannot record more than
markers.
Delete unnecessary chapter
33
(
VR Format Disc
)
There is 999 number of total chapter.
9
as Control Information is full.
You cannot record on this disc
Delete unnecessary titles. 34
control information.
There is not a space to a record field of
10
You cannot record on the
disc as Power Calibration
Area is full.
Insert a new disc. 35 PCA Full.
(
in REC start
)
4
This disc is already
finalized.
disc.
Release the finalizing for this
Can not record on this disc.
Repeat the same operation.
36 It is done Finalize.
(
Video Format Disc
)
6
37 Access to Memory Area range outside. -
38 Sector Address is wrong. -
39 BUP writing error of chapter editing. -
If an error occurs during the timer recording, one of the following error numbers (40 to 42) or the above error messages
(error number: 1 to 39) is displayed on the recording menu after timer recording.
(Once the screen of the program line is exited, the program line for the error will be cleared.)
(No Error Message is displayed for the error No. 40 ~ 42.)
Timer Programming
2. ---
3. ---
4. ---
5. ---
6. ---
7. ---
8. ---
*
JAN/01 12:57AM 1:57AM 8 DVD E40
Date Start End CH Speed
DVD
VCR
VCR DVD
A program with the error number is grayed out and asterisked on the timer programming list.
The speed mode changes
to the error number.
Message Solution
No.
Error
Error Description Priority
Error message is not
displayed.
- Set the timer programming
correctly.
- Set the timer programming
before the start time.
- Insert a recordable videotape
with a record tab.
Turn the power on and set the
clock correctly then set timer
programming again.
Insert the recordable disc.
40
- Some portion has not been recorded
because of program overlapping.
- Recording did not start at the start time.
- No Videotape is inserted.
Videotape ran out during recording.
-
41
Power failed
-
42
No disc when recording
-
To Next Page
Loading...
