101
Chapter 6: Advanced Graphing Features — Advanced Keyboard
User: Displays a blank table. As you input values for variable columns,
table values are automatically calculated by the equation. Thus,
although TableStart and TableStep inputs can be made when
selecting User, set values will be ignored.
• Press ; or ' to switch between Auto and User.
•
Ta bleStart is a start value of the variable in the table, and
Ta bleStep is a step value of the variable. Both are numeric values.
Example
Automatically create a table starting from
-5 with a step of 1 in the
X-Y coordinate after equations, based on “Y1 = X”, “Y2 = X
2
”, and
“Y3 =
-X
2
+ 3”.
1. Press @ y and
} _ 5 E 1
E.
2. Press T.
* If the cursor is on the top or bottom line of the table, { or
} can still be used. The table contents will move to become
visible in the display area.
Example
Create a table in the User mode under the above conditions.
1. Press @ y and
' E } 0 E
1 E.
2. Press T.
Blank table will appear.
3. Press 2 E _ 3
E to enter X values.
*
An automatically created table in the User mode cannot be scrolled vertically.
Note: While the table is in the User mode, a selected row can
be deleted by pressing D.
084_114_chapter6_en 02.8.23, 2:07 PM101
To Next Page
Loading...
